Comprehensive supplier audit data

List of catalogs of this article:

• 1, How to disassemble the car oil pipe card?
• 2
  、Comprehensive supplier audit data' title='Chang'an car luggage rack card?' > Chang'an car luggage rack card?
• 3 、 How to remove the car lining card?

How to disassemble the car oil pipe card?

1. Disassembly method of automobile oil pipe card: a detachable production method of automobile oil pipe tube card, a detachable automobile oil pipe tube card, mainly including tube card holder, tube card cover and snap part; tube card holder and tube card cover are connected through coaxial hinges, and the buckle is set in front of the tube card cover. End, in the shape of a barb.

2. The way to disassemble the automobile oil pipe connector is to hold the oil pipe down, and hold the black card with the other hand to lift the card up. If the black card moves, the pipe will fall off. It is recommended that two people operate it together.

3. Prepare a tool dedicated to removing snaps. Take out the tool and place it on the snap, so that it is properly aligned and tight with the snap. Use the handle of the tool to force down until the latch is removed from the original position.

Chang'an car luggage rack card?

How to install the Chang'an car luggage rack card to fix the luggage rack card: use appropriate tools to fix the luggage rack card to the car body. Generally speaking, the fixed part needs to be firm and reliable to avoid loosening and other problems during driving. Adjust the height and direction: Adjust the height and direction of the luggage rack card according to the needs of the car body.

There are fixed snaps or screws at both ends and in the middle of the luggage rack. You can open the black decorative cover and see how it is fixed inside.

The load-bearing roof rack in the Chang'an Cs85 configuration refers to the luggage rack installed on the roof of the vehicle. It can carry luggage, save space in the vehicle, and improve the space utilization of the vehicle.

In theory, the car luggage rack on the roof can place things. But nowIn fact, the roof rack of our car is glued with 3m glue, and it is not fastened with screws. If something is placed, the car may cause items to fall and cause safety accidents when accelerating and braking.

How to remove the car lining card?

Car lining buckle removal method: The trunk lining buckle removal method is simple, no need to ask. It's a miracle to ask. Use a special tool or a small flat-head screwdriver to pry open the middle round head, and then wedge or pull it out with a tool. It is normal for the teeth to slide in smoothly, and the teeth are stuck in reverse. The snap is directly exposed and inserted into the hole of the metal plate.

First of all, you can gently pry it open with a screwdriver before pulling it out. There are also professional disassembly tools, which can be purchased in some stores or online.Secondly, if the snaps are damaged, they can be easily replaced, because they only cost a few cents.

The rear windshield lining method is as follows: 1 Remove the two screws under the rear windshield lining plate first. 2 Then put the screwdriver in and pry it hard from below, and the card will open. 3 This kind of card is not broken when prying. There are three cards on the left and right. After the card is pryed open, it is removed when it is picked up.

You can gently pry it with a word change cone and then pull it out. There is also a professional tool to disassemble the buckle, which is basically sold in some stores or on the Internet. Car lovers can buy it; it doesn't have to be important if the buckle is broken. Because the buckle is only a few cents each, it can be replaced with a new one.