1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
European trade compliance guidelines-APP, download it now, new users will receive a novice gift pack.
1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
Automated import export risk alerts
author: 2024-12-23 22:18Navigating HS code rules in Latin America
author: 2024-12-23 21:11Processed foods HS code mapping
author: 2024-12-23 21:06Trade data for healthcare supplies
author: 2024-12-23 20:42How to simplify export documentation
author: 2024-12-23 20:41Brazil import trends by HS code
author: 2024-12-23 23:00Cross-verifying suppliers by HS code
author: 2024-12-23 22:58Special economic zones HS code strategies
author: 2024-12-23 22:56Processed fruits HS code insights
author: 2024-12-23 22:43Predictive supply chain resilience
author: 2024-12-23 22:31446.66MB
Check937.77MB
Check392.72MB
Check298.24MB
Check819.58MB
Check992.12MB
Check437.94MB
Check831.28MB
Check179.23MB
Check671.55MB
Check615.72MB
Check977.71MB
Check176.52MB
Check295.32MB
Check682.78MB
Check155.48MB
Check683.41MB
Check247.73MB
Check412.77MB
Check557.44MB
Check854.49MB
Check354.48MB
Check415.43MB
Check587.59MB
Check345.62MB
Check216.38MB
Check825.19MB
Check333.89MB
Check984.74MB
Check213.69MB
Check543.23MB
Check914.45MB
Check518.26MB
Check159.47MB
Check898.79MB
Check126.52MB
CheckScan to install
European trade compliance guidelines to discover more
Netizen comments More
984 Trade intelligence for luxury goods
2024-12-23 21:46 recommend
2551 How to align trade data with demand planning
2024-12-23 21:35 recommend
443 Renewable energy equipment HS code mapping
2024-12-23 21:24 recommend
845 Cross-border HS code harmonization
2024-12-23 21:19 recommend
1527 HS code lookup for Asia-Pacific markets
2024-12-23 20:48 recommend