1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
Deriving product origin via HS code-APP, download it now, new users will receive a novice gift pack.
1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
HS code-based compliance checks for EU
author: 2024-12-23 23:01How to ensure stable supply lines
author: 2024-12-23 22:46Comparative supplier performance data
author: 2024-12-23 22:24Sourcing intelligence from customs data
author: 2024-12-23 20:30Russia HS code-based trade compliance
author: 2024-12-23 20:29High-value machinery HS code classification
author: 2024-12-23 21:02Wine and spirits HS code verification
author: 2024-12-23 20:48Drilling equipment HS code mapping
author: 2024-12-23 20:38HS code mapping to trade agreements
author: 2024-12-23 20:24186.21MB
Check244.31MB
Check315.46MB
Check793.75MB
Check975.44MB
Check649.21MB
Check753.75MB
Check923.14MB
Check164.12MB
Check729.95MB
Check168.17MB
Check961.41MB
Check583.54MB
Check648.28MB
Check633.49MB
Check227.32MB
Check358.37MB
Check951.42MB
Check773.67MB
Check845.86MB
Check936.81MB
Check368.57MB
Check336.14MB
Check522.98MB
Check332.67MB
Check197.39MB
Check417.63MB
Check553.83MB
Check511.13MB
Check498.52MB
Check248.66MB
Check185.55MB
Check248.91MB
Check125.58MB
Check133.83MB
Check429.21MB
CheckScan to install
Deriving product origin via HS code to discover more
Netizen comments More
173 Pharmaceutical intermediates HS code mapping
2024-12-23 23:02 recommend
1629 Export packaging standards by HS code
2024-12-23 21:45 recommend
1440 Global trade risk heatmaps
2024-12-23 21:34 recommend
411 Agriculture trade data intelligence
2024-12-23 20:55 recommend
101 HS code compliance for Pacific Island nations
2024-12-23 20:37 recommend