1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Grain imports HS code data trends-APP, download it now, new users will receive a novice gift pack.
1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Customs procedure optimization
author: 2024-12-23 22:51Processed foods HS code mapping
author: 2024-12-23 21:49CIS countries HS code usage patterns
author: 2024-12-23 21:18Container freight index monitoring
author: 2024-12-23 21:15How to interpret bill of lading data
author: 2024-12-23 20:22Global trade partner compliance checks
author: 2024-12-23 22:55High-tech exports HS code categorization
author: 2024-12-23 21:42Gourmet foods HS code classification
author: 2024-12-23 20:45538.89MB
Check615.43MB
Check358.35MB
Check818.55MB
Check336.58MB
Check366.31MB
Check752.31MB
Check639.11MB
Check876.14MB
Check176.21MB
Check754.28MB
Check639.75MB
Check798.95MB
Check459.66MB
Check358.54MB
Check762.98MB
Check561.56MB
Check132.65MB
Check272.44MB
Check655.97MB
Check266.13MB
Check879.17MB
Check563.87MB
Check464.21MB
Check472.18MB
Check667.95MB
Check759.81MB
Check325.25MB
Check162.43MB
Check842.24MB
Check186.66MB
Check829.97MB
Check293.76MB
Check155.48MB
Check995.13MB
Check468.26MB
CheckScan to install
Grain imports HS code data trends to discover more
Netizen comments More
2352 Europe import export statistics
2024-12-23 22:33 recommend
2572 Global trade metadata enrichment
2024-12-23 21:54 recommend
237 How to analyze trade seasonality
2024-12-23 21:25 recommend
612 Advanced tariff classification tools
2024-12-23 20:49 recommend
2134 How to use data for HS code classification
2024-12-23 20:22 recommend