HS code compliance for South American markets

List of contents of this article:

• 1,Car Oil Leak
• 2、 What should I do if the engine leaks oil?
• 3, How to deal with car engine oil leakage

Automobile oil leakage

1. The screw is not tightened or not smooth: When the vehicle is repaired, the screw of the oil span is not tight enough, which will make the sealing performance between the body and the oil span worse, and oil leakage will also occur during driving. When repairing and maintaining the vehicle, you should pay attention to the oil span screw washer.

2. Due to the difference in air pressure inside and outside the box, oil leakage often occurs in the weak seal. Attachment: Common form of oil leakage: oil splash: there are traces on the top, bottom, left and right, irregular, large area.

3. Engine oil leakage refers to the oil leakage to the outside. This is a common problem in the use of cars. This is because when the engine is running, the internal pressure is too high, and the internal pressure of the machine is too high. The waste pressure makes the engine washer restart, and the oil seeps out to the outside through the washer.Of course, this is the most common thing.

What should I do if the engine leaks oil?

Replace the seal: If the cause of the oil leakage is hardening, aging or damaged seal, it is necessary to replace the new seal in time, and check to ensure that there is no oil leakage after replacement. Repair or replace the guard plate: If the oil leak is caused by the guard plate falling off or damaged, the guard plate should be repaired or replaced in time to avoid such failures next time.

The solution to engine oil leakage: valve chamber cover oil leakage. The car that has been used for about 5 years is relatively expensive, and the valve chamber cover pad needs to be replaced; the engine timing cover leaks oil. Remove the engine timing cover and re-glue; the oil release screw of the oil san is loose or damaged.

Therefore, solveThe following measures need to be taken for the problem of automobile oil leakage: it is necessary to identify the leakage point first, such as the oil span, the oil span screw, the oil pipe, the front oil seal of the crankshaft, the rear oil seal, the camshaft oil seal, the valve cover gasket and other parts. Most oil leaks are engine oil leaks, and transmission oil leaks are relatively rare.

Engine oil leakage is usually caused by the following reasons: oil release screw leakage, oil leakage. If necessary, the bolts should be tightened and/or the washers and oil seals should be replaced. The lubricating oil leaks at the oil release bolt of the engine bottom plate (oil span shell). If such a failure occurs, please replace the oil sap bolts appropriately.

Due to the serious oil leakage of the valve chamber cover, there is a lot of oil on the engine and gearbox body, and the engine should be cleaned with external cleaning agent. In fact, there is no need to repair this small detail. The owner can find a cover of the same specification and replace it.

The solution to engine oil leakage: It mainly depends on how the engine leaks oil. If it is slight oil leakage, just replace the sealing ring or gasket.

How to deal with car engine oil leakage

1. For engine oil leakage, we can takeTake the following treatment methods: valve chamber cover oil leakage: this is very common in German and French vehicles, especially in vehicles that have been used for more than 5 years. The main reason for oil leakage is the aging of sealant and rubber valve cover gaskets.

2. Oil radiator or oil filter base, if the oil radiator and filter base gasket is aging, resulting in loose sealing and oil leakage, along the oil marks, the cause of oil leakage is very easy to find, just replace the gasket directly.

3. If only a small amount of oil seeps out, it is normal. This is because there is a common phenomenon in the long-term use of the engine.

4. Replace the valve chamber cover pad. The oil leakage of the car is related to the leakage of the valve chamber cover. At this time, the valve chamber cover pad can be replaced. Replace the oil release screw gasket. The oil leakage of the car may be caused by the aging of the screw gasket. Just replace it.

5. If the engine oil span leaks, it is due to the aging of the oil span sealant, which needs to be removed, replaced with the oil span seal and re-glued. If the oil drain screw is loose or damaged, the drain screw should be tightened or replaced.