HS code compliance for South American markets

List of catalogs of this article:

• 1, How to operate the automobile manual transmission
• 2 、< A href='#correct operation of manual transmission car start' title='correct operation of manual transmission car start'>ManualThe HS code compliance for South American marketscorrect operation of the start of the car
• 3, Understand the key points of the operation of the six major parts of the automobile
• 4, How to operate an automatic transmission car! Thank you!

How to operate the automobile manual transmission

1. Step on the clutch and stwist the key to ACC gear, stay up and down for 3 to 5 seconds and then turn to START gear to ignite; step on the clutch to hang one gear, release the handbrake. Manual transmission is a car that uses a manual shift pedal gearbox to adjust the speed of the hour. It is to turn the gear lever to change the mesh position in the gearbox, change the transmission ratio, and complete the gearbox effect.

2. Manual transmission cars control the clutch gear lever by hand, which controls the car's forward or backward, and the forward speed. Specific operation method: The first step in the car is to fasten the seat belt. The seat belt is on the left side of the driver's seat, which can be stretched freely, and the seat belt can be pulled out and stuck into the slot on the right.

3. The correct operation of the car with manual transmission is as follows: before driving, walk around the car and observe whether there are any special circumstances. After getting on the car, adjust the seat position and the angle of the left and right rearview mirrors according to the body comfort. After adjustment, fasten your seat belt, brake on the clutch, and turn on the turn signal.

4. First-speed start: Step on the clutch when the vehicle starts, and then gently light the accelerator, look at the tachmometer to about 2000 rpm, release the clutch, send the handbrake, and the vehicle starts. Remember the first pedal, second hanging, third steering, fourth release of the handbrake, and five horns taught by the driving coach.

5. The manual transmission should be changed according to the speed of the car. Under normal circumstances, start the first gear, and when you drive a few meters, then change to the second gear; when the speed reaches more than 20 miles and 35 steps, change to the third gear; when the speed reaches more than 35 miles, change to the fourth gear after 45 miles;If the speed reaches more than 45 miles, change to five gears.

6. Shifting skills of manual transmission cars: When changing gears, you must keep in mind the principle of "accelerate first when upshifting and slow down first when downshifting". Before downshifting and changing gears, the clutch pedal must be stepped on to the end, and the shift lever should be operated gently. Change gears according to the speed of the car. Under normal circumstances, start from the first gear and change to the second gear after driving a few meters.

Correct operation of manual transmission car start

Confirm gear position and handbrake. Make sure that the gear is idle and the handbrake is in a pull-up state. Hang gear. Step on the clutch pedal and brake pedal, start the engine, put the gear in 1st gear, and then release the handbrake. Lift the clutch.

The correct way to start the manual transmission is as follows: step on the clutch pedal and hang the gearshift lever into the first gear.Press the horn and relax the handbrake.

The correct step for manual gear start is 1 completely step on the clutch 2 hang the gear to 1st gear 3 turn left turn signal 4 press the horn to remind 5 release the handbrake 6 lift the clutch with the left foot 7 the vehicle starts, the clutch of the left foot should be stable, no pressure down or lift operation, avoid ignition 8 steady.

The manual gear start is to step on the clutch, step on the gear, turn on the turn, turn the horn, turn the horn, release the brake, release the clutch, and start with oil. It should be noted that you must step on the clutch to the end, otherwise it will cause great damage to the gearbox. Don't loosen it too fast when loosening the clutch, otherwise it will turn off.

Understand the key points of the operation of the six major parts of the car

1. (1) Get in and out of the car. You must close the car door, sit upright, look ahead, and hold the steering wheel at 9 o'clock left and 4 o'clock right. ( II) Start the car. First, check whether the relevant equipment is normal, confirm the idle gear, open the electric door and turn on the motor, and check whether the instrument is running normally. ( III) Start.

2. If your car is equipped with a one-button start function, you only need to unlock and start the car key close to the induction area.

3. Driving skills, light refueling, light braking, early braking, sudden braking, sudden starting, and sudden accelerator are all fuel-saving taboos. The fuel-saving test shows that stepping on the accelerator costs 2 to 3 times more fuel than driving at medium speed. Therefore, under the premise of ensuring the normal operation of the car, the throttle amplitude should be appropriately reduced.

4. Tips for the maintenance of 6 major systems of automobiles 1 Car maintenance and car repair are closely related. There is maintenance in repair, and there is repair in maintenance. During the maintenance process of the vehicle, it may be found that a part or part will be faulty or damaged, so it can be repaired during the maintenance time.

5. Detailed explanation of the six major maintenance system maintenance skills of the car, cleaning and maintenance of the power steering system, every 40,000 kilometers-45,000Kilometer, the car needs to be cleaned and maintained once, or the system leaks due to steering difficulties. After replacing the power steering parts, it should also be cleaned and maintained once.

How to operate an automatic transmission car! Thank you!

The operation process of automatic transmission cars is as follows: start. Get in the car and plug in the key to start the ignition. About 1-2 minutes after the ignition, the speed goes down to about 1000 rvels. Step on the brake with your right foot, hang the gear, hang the gear in D gear, then release the handbrake, and slowly lift your right foot. At this time, the vehicle begins to move forward.

The operation steps of the automatic transmission car are: after the driver sits in the driver's seat, press the start button directly; step on the brake and press the start button for ignition; release the foot brake and heat the car in place; step on the brake again and hang the d gear;Release the handbrake and slowly release the foot brake to start.

Operation method of the automatic transmission of the car: After the driver sits in the driver's seat, press the start button directly; step on the brake and press the start button to start the ignition; release the foot brake and heat the car in place; step on the brake again and hang up the D gear; release the handbrake and slowly release the foot brake to start.

The specific operation steps for driving an automatic transmission car are as follows: step on the brake pedal of the automatic transmission car. Press the one-button start button of the automatic car. The instrument of the automatic transmission car lights up and the vehicle starts. Put the automatic transmission lever of the automatic transmission car in the P position, which is a long-term parking gear.

The driving steps of the automatic transmission car are as follows: the correct driving steps of the automatic transmission car. In the first step, plug in the key, turn to the nearest position to start the car and pause, or press the power button to turn on the power, so that the car can automatically detect for about 30 seconds.Step 2: Step on the brake or pull the driver to the handbrake and turn on the n gear ignition.

When the control handle is put into the forward gear, release the brake pedal, and as the refueling and engine speed increase, the torque transmitted increases, pushing the car forward.